2015 Mazda Mazda3

2015 Mazda Mazda3 recalls (4)

• FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY

  Mazda Motors North American Operations (Mazda) is recalling certain model year 2014-2016 Mazda3 vehicles manufactured January 4, 2014, to September 18, 2015. The fuel tank of the affected vehicles may have been improperly handled during manufacturing and, as a result, the welded attachment of the Inlet Check Valve (ICV) may fail and allow fuel to leak.

  Remedy: Mazda will notify owners, and depending on the tank lot number, dealers will inspect the ICV weld, replacing the fuel tank, as necessary, free of charge. The recall began November 1, 2016. Owners may contact Mazda customer service at 1-800-222-5500. Mazda's number for this recall is 0116I.

• PARKING BRAKE

  Mazda North American Operations (Mazda) is recalling certain 2014-2015 Mazda6 and 2014-2016 Mazda3 vehicles. Water could possibly enter the brake caliper causing the parking brake actuator shaft to corrode and possibly bind.

  Remedy: Mazda will notify owners, and dealers will check the parking brake actuator shafts, replacing any that are corroded, free of charge. Remedy parts are currently unavailable. Interim notices informing owners of the safety risk were mailed August 24, 2017. Owners will receive a second notice when remedy parts become available. Owners may contact Mazda customer service at 1-800-222-5500. Mazda's number for this recall is 1217F.

• FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY

  Mazda North American Operations (Mazda) is recalling certain model year 2015-2016 Mazda3 vehicles manufactured May 21, 2015, to August 25, 2015. The affected vehicles are equipped with a fuel tank with a shut-off valve that can allow fuel to enter into the fuel tank emissions systems. If enough fuel enters the emission system it may leak out onto the ground or result in an engine stall.

  Remedy: Mazda will notify owners, and dealers will inspect the vehicle's fuel shut-off valve. As needed, the fuel shut-off valve and the affected fuel tank emissions system components will be replaced, free of charge. The recall began on October 20, 2015. Owners are advised not to drive their vehicle until the repairs have been completed. Mazda will provide rental cars until that time. Owners may contact the Mazda Customer Experience Center at 1-800- 222-5500, option #6. Mazda's number for this recall is 8615J.

• BACK OVER PREVENTION: SENSING SYSTEM: CAMERA

  Mazda North American Operations (Mazda) is recalling certain 2014-2018 Mazda3 and 2016-2021 CX-3 vehicles. The rearview camera image may not display properly by showing a flickering or distorted image.

  Remedy: Dealers will inspect and replace the rearview camera, as necessary. In addition, dealers will install a wiring harness fastening seal. All repairs will be performed free of charge. Interim notification letters, notifying owners of the safety risk, were mailed September 13, 2023. Final owner letters for affected models and model years in the states of CT, MA, MD, NJ, NY, PA and VA were mailed August 14, 2024. The remaining owner notification letters will be mailed at a future date, anticipated on or before May 1, 2025. Owners may contact Mazda customer service at 1-800-222-5500, Option 6. Mazda's number for this recall is 6023G.

2015 Mazda Mazda3 safety ratings

Source: NHTSA NCAP ratings.

2015 Mazda Mazda3 owner complaints (15)

• BACK OVER PREVENTION

  The contact owns a 2015 Mazda Mazda3. The contact stated that while driving at various speeds, or while attempting to reverse, the rear camera flashed on and off for approximately five minutes and then started working as intended. No warning light was illuminated. The vehicle was repaired under the NHTSA Campaign Number: 23V487000 (BACK OVER PREVENTION) by the owner of the vehicle; however, the fix failed to repair the vehicle. The contact stated that the failure had occurred after the recall repair was performed. The manufacturer was not notified of the failure. The failure mileage was 180,000.

• FUEL/PROPULSION SYSTEM

  While parked on a slight downhill grade, gasoline started leaking and created a significant puddle on the ground. No warning lamps, messages or other symptoms. An independent service center ran numerous tests over two days, including a smoke test. Diagnosis: There is a hole in top section of fuel tank and the fuel tank needs replaced. Recommendation was to not drive vehicle with fuel tank over half full. Due to the potential of leaking fuel in the presence of a hot ignition source increasing the risk of fire, driving the vehicle long distance with defective fuel tank appears to represent an unreasonable safety risk. Unfortunately, the vehicle is currently 300 miles from home. Mazda’s Mexican-made plastic fuel tank specifically required for our vehicle’s VIN is not currently available. (Mazda makes a similar metal fuel tank in [XXX] which will not fit.) Mazda has an estimated three-month backlog in [XXX] for the fuel tank. Still awaiting repair due to lack of availability of the appropriate fuel tank. Major safety recall NHTSA 16V684000 for the 2015 Mazda3 addresses a manufacturing defect where a fuel tank weld could fail, leading to fuel leaks and a potential fire. Recall is for vehicles produced between 12/4/13 – 9/18/15. Our vehicle was manufactured 02/2015 in [XXX] . However, recall is limited to three specific series of VINs and our vehicle falls in the gap between subject VIN ranges. A recent NHTSA complaint XXX (1/27/26) has the same issue: fuel tank leak, but not within range of recall VINs. It seems that the list of affected VINs included in recall 16V684000 should be expanded to include additional Mexican manufactured vehicles potentially with the same issue. Or create a new recall. Having a hole in the top of a plastic fuel tank securely mounted to the vehicle is unexpected through normal wear and tear. Any fuel leakage increases the risk of fire. NHTSA should investigate if this is due to a defect in Mazda’s manufacturing process. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

• FUEL/PROPULSION SYSTEM

  Fuel leaking out of top of tank. Took car to two different shops. They both told me about a recall on the gas tank. They did every test possible and replaced O ring. Even did smoke evap system test. Tank still leaks from the top when full. They said the tank needs replaced. There is a recall for the year make and model but not my VIN?

• SERVICE BRAKES

  Description On 12-15-2025, in 18°F weather, the vehicle was parked on a residential sloped driveway with the manual parking brake fully engaged. While the driver was outside the vehicle, the parking brake system failed to hold the car’s weight. The vehicle rolled backward, crashed through a wooden railing, teetering on a 4-foot retaining wall, and came to rest over a culvert. Two young children were inside the vehicle at the time of the failure. Component Failure & Availability: The manual parking brake system failed to provide sufficient holding force to secure the vehicle. The rear brake calipers are currently available for inspection. Safety Risk: The safety of the two children inside the vehicle was put at extreme risk due to the unexpected movement of the car. This failure matches the exact conditions and consequences described in Safety Recall 1217F (NHTSA Campaign 17V-393), which states that "unexpected movement of the vehicle if parked on a slope" increases the risk of a collision. Reproducibility & Confirmation: The failure occurred under the specific environmental triggers (cold temperature and slope) identified in the manufacturer's own safety recall documentation. However, the manufacturer has officially refused to authorize the internal teardown of the actuator shafts—the only diagnostic method capable of verifying the rust and sliding resistance that causes this loss of holding force. Inspections: The vehicle has been visually inspected by an authorized dealership and insurance representatives. The manufacturer has declined the necessary internal mechanical diagnostics to verify the internal defect. Warning Symptoms: There were no warning lamps, messages, or symptoms prior to the failure. The parking brake felt fully engaged at the time the vehicle was parked.

• ENGINE,FUEL/PROPULSION SYSTEM

  Catalytic converter keeps giving me check engine

• UNKNOWN OR OTHER

  I had purchased a car through Facebook Marketplace after talking to the seller and seeing a CarFax report on the car we decided to purchase it. After coming home the following day I look closer at the documents and realized the CarFax did not match the VIN of the car I purchased. After looking up the CarFax with the VIN on the car I purchased I saw that the person who sold me the car had rolled back the odometer.

• BACK OVER PREVENTION

  The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (BACK OVER PREVENTION). However, the dealer refused to complete the recall repairs due to the vehicle having a Salvage Title. The contact stated that the rearview camera displayed a black screen while the vehicle was in reverse(R). The contact stated that the failure obstructed the driver's visibility, which prevented the driver from safely operating the vehicle. The manufacturer was made aware of the issue and referred the contact back to the dealer. The vehicle remained unrepaired. The failure mileage was approximately 86,000.

• PARKING BRAKE

  The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 17V393000 (Parking Brake); and would like to be removed from the recall distribution list. The local dealer and manufacturer were not contacted.

• UNKNOWN OR OTHER

  The vehicle automator mileage was changed. The original mileage reading is over 200,000 mi. While the dashboard mileage only reads 90,780 mi. I was unaware of this until I went to the DMV to do a title transfer. The private seller is now nowhere to be found from Facebook marketplace and has blocked me but I do have receipts of everything

• ELECTRICAL SYSTEM

  The Infotainment System will randomly change radio stations while driving, or start scanning through the various system menus, and on at least in one case, started randomly making phone calls from a connected phone. This creates a major distraction while driving. This has been looked at by the dealership and would cost $1500 for the system repair. I understand that this is a known problem.

• POWER TRAIN

  1. Automatic transmission suffered a catastrophic failure during operation. Transmission was discarded by Bountiful Mazda, Utah. 2. Both other and I were at risk as the vehicle could not be controlled. 3. I read similar findings on Social Media posts. 4. Bountiful Mazda confirmed metal shavings in the drain trans fluid. 5. No prior warning on car instrumentation, or while driving, or on prior inspection by Cardinaleway Mazda, Gilbert, AZ 6. Neither Mazda USA (Mfr) nor Protective Asset Protection have taken responsibility for the initial equipment failure nor reimbursement through the extended service contract even with extenuating circumstances for late notification. I can provide copies of additional relevant material.

• FUEL/PROPULSION SYSTEM

  Since the middle of 2023 I have noticed a gas fume smell both inside and outside of my 2015 Mazda Mazda3 after I fill my gas tank to full. This smell persists up until I use about a half tank of gas or slightly less. I do not top my gas tank off and stop filling when the automatic gas pump stops. There are no visible leaks on or around the gas tank or below the vehicle, and there are no noticeable cracks around the gas tank, valves, lines, etc. Additionally, there are no warning lights present on my dashboard or any codes.

• ELECTRICAL SYSTEM

  The Mazda Connect touch screen in the center display may not accept touch commands properly or may operate by itself (ghost touch). The ITO (Indium Tin Oxide) film of the touch screen may be corroded due to moisture, which may adhere on the lens of the touch screen during the cleaning process at the plant. The corrosion may allow the electrostatic capacity to vary without any input, causing the malfunction of the touch screen.

• ELECTRICAL SYSTEM

  Mazda call this “ghost touch” it happens when the screen starts to act up like crazy, jumping from different audio sources, Bluetooth lose connection, making unwanted phone calls. Almost like a ghost is touching the screen over and over again.

• BACK OVER PREVENTION

  The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was unavailable. The local dealer was contacted, and it was confirmed that the part was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact stated that the back-up camera screen image was flickering and became distorted while reversing. The cause of the failure was not determined. The failure mileage was 60,000. VIN tool confirms parts not available.