2012 Mazda Mazda6

2012 Mazda Mazda6 recalls (6)

• AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

  Mazda North American Operations (Mazda) is recalling certain 2014-2015 Mazda CX-9 vehicles sold, or ever registered in the states of Alabama, California, Florida, Georgia, Hawaii, Louisiana, Mississippi, South Carolina, Texas, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands or "Zone A." Additionally, unless covered in "Zone A," Mazda is recalling certain 2011-2013 Mazda6, 2011-2012 CX-7, and 2011-2015 CX-9 sold, or ever registered in the states of Arizona, Arkansas, Delaware, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia, West Virginia and the District of Columbia, or "Zone B." Additionally, unless covered in Zone A or Zone B, Mazda is recalling certain 2010-2013 Mazda6, 2010-2012 CX-7, and 2010-2015 CX-9 vehicles ever registered in the states of Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin, and Wyoming or "Zone C." These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these inflators may explode due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.

  Remedy: Mazda will notify owners, and dealers will replace the front passenger air bag inflator with an alternate inflator, free of charge. The recall began November 9, 2018. Owners may contact Mazda customer service at 1-800-222-5500, Option 4. Mazda's number for this recall is 1317F.

• AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

  Mazda North American Operations (Mazda) is recalling certain 2007-2012 CX-7, CX-9, and 2009-2012 Maza6 vehicles. These vehicles had their passenger frontal air bag inflators previously replaced under a prior recall using inflators of the same design. The inflators may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, temperature and temperature cycling.

  Remedy: Owners are advised not to drive their vehicles until the repair has been performed. Mazda will notify owners, and dealers will replace the front passenger air bag inflator with an alternate one, free of charge. The recall began December 3, 2019. Owners may contact Mazda customer service at 1-800-222-5500, option 4. Mazda's number for this recall is 1317F. Note: This recall supersedes recalls 16V356 and 17V012.

• STRUCTURE

  Mazda North American Operations (Mazda) is recalling certain 2011-2013 Mazda6 vehicles sold, or ever registered in Connecticut, Delaware, the District of Columbia, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland,Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, and Wisconsin. The front cross member may corrode after exposure to road salt.

  Remedy: Mazda will notify owners, and dealers will inspect the cross member and either install a side member and drain hose and apply wax to protect from rust, or install a drain hose and an improved front cross member, free of charge. The recall began June 13, 2019. Owners may contact Mazda customer service at 1-800-222-5500 Option 4. Mazda's number for this recall is 2818I. Note: This recall is an expansion of Recall 18V-631.

• AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

  Mazda North America Operations (Mazda) is recalling certain 2012 CX-7, CX-9 and Mazda6 vehicles sold, or ever registered, in the states of Alabama, California, Florida, Georgia, Hawaii, Louisiana, Mississippi, South Carolina, Texas, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands, or "Zone A." Additionally, unless included in "Zone A" above, Mazda is recalling certain 2009 CX-7, CX-9 and Mazda6 vehicles sold, or ever registered in the states of Arizona, Arkansas, Delaware, District of Columbia, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia, and West Virginia, or "Zone B." Additionally, unless included in "Zone A" or "Zone B" above, Mazda is recalling certain 2007-2008 CX-7 and CX-9 sold, or ever registered in the states of Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin, and Wyoming. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these inflators may rupture due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.

  Remedy: Owners are advised not to drive their vehicles until the remedy is performed. Mazda will notify owners, and dealers will replace the front passenger side air bag inflator with an alternate inflator, free of charge. The recall began October 4, 2017. Owners may contact Mazda customer service at 1-800-222-5500. Mazda's number for this recall is 1317F. Note: This recall supersedes recall 17V-012.

• FUEL SYSTEM, GASOLINE

  Mazda North America Operations (Mazda) is recalling certain model year 2010-2012 Mazda6 vehicles manufactured September 14, 2009, through May 2, 2011, and equipped with 2.5L engine. In the affected vehicles, spiders may weave a web in the evaporative canister vent hose, blocking it and causing the fuel tank to have an excessive amount of negative pressure.

  Remedy: Mazda will notify owners, and dealers will reprogram the powertrain control module and inspect and clean the canister vent line. If a web was found in the line, the fuel tank and check valve on canister vent line will be replaced. These repairs will be done free of charge. The recall began on April 30, 2014. Owners may contact Mazda at 1-800-222-5500. Mazda's recall number associated with this campaign is 7214C.

• LATCHES/LOCKS/LINKAGES:DOORS:LATCH

  Mazda is recalling certain model year 2009-2013 Mazda6 vehicles manufactured February 4, 2008, through August 24, 2012. The door latch mounting screws may become loose.

  Remedy: Mazda will notify owners, and dealers will apply a thread locking adhesive to the door screws and retorque them, free of charge. The recall began on October 29, 2013. Owners may contact Mazda at 1-800-222-5500. Mazda's recall number is 7013I.

2012 Mazda Mazda6 safety ratings

Source: NHTSA NCAP ratings.

2012 Mazda Mazda6 owner complaints (15)

• UNKNOWN OR OTHER

  Passenger dash has cracked some and dash is very very sticky..why has this happened..I feel if airbag had to deploy it would not because of this situation

• SUSPENSION,UNKNOWN OR OTHER

  The rear subframe and suspension parts are rusted so bad that the car is not safe to drive. Looked up recalls and found out the front subframe had a recall and was taken care of before I bought the car. Also found recall for my model of car that were registered in state that use salt on there roads which is one of the state i live in. Was told my Mazda corporation the only certain 2012 mazda vehicle's vehicle's were covered for rusting issues with the rear . If the front of the car is recalled and the same problem happens with the rear of the car shouldn't it be covered for something? I have an appointment coming up on the 21 of January which is ridiculous that I have to wait 3 weeks to have it looked at. . Thank you for your time. The only reason I found the problem with the car was a stick got stuck in the rusted out parts and when I took it out a bunch of rust fell on the ground.

• SUSPENSION,STRUCTURE

  The contact owns a 2012 Mazda Mazda6. The contact stated while driving 55 MPH and crossing a bridge, the vehicle stopped unexpectedly after driving over several expansion joints. The contact stated that the vehicle had not stalled. The contact exited the vehicle and noticed that the passenger’s side front wheel was slanted into the wheel well. The contact inspected the wheel well and noticed that the control arm had sheared off at the cross member. The contact stated that prior to the failure, the steering wheel had turned slightly to the right. The contact researched online and related the failure to NHTSA Campaign Number: 19V323000 (Structure, Suspension), which included the VIN. The contact stated that the vehicle was towed to a dealer, where the contact was advised that the VIN was included in a recall, and the contact was advised that the vehicle needed to be diagnosed to determine the cause of the failure. The contact stated that the dealer had not diagnosed vehicle in a month. The manufacturer was informed of the failure and advised the contact to work with the dealer. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer and dealer had exceeded a reasonable amount of time for the recall repair. The failure mileage was approximately 188,000.

• SUSPENSION,STRUCTURE

  The contact owns a 2012 Mazda Mazda6. The contact stated while driving 55 MPH, the steering wheel began to shake violently, with the low tire pressure warning light illuminated. The contact pulled over to inspect the vehicle and discovered that the front passenger’s side tire had detached from the vehicle. The contact's father was called to the scene and the spare tire was placed on the vehicle. The contact then drove to an independent mechanic where both the front driver’s and front passenger’s side tires were replaced. The manufacturer was notified of the failure and referred the contact to the dealer for assistance. The vehicle was taken to the dealer where a diagnostic test was performed; and the diagnostic test determined that the cross member had corroded and caused the tire failure. The contact was then notified that the vehicle was not covered under NHTSA Campaign Number: 19V323000 (Structure, Suspension) and that the warranty on the vehicle had expired. The vehicle remained in the possession of the dealer and was not repaired. The failure mileage was 204,000.

• SUSPENSION

  Front subframe completely rusted out causing loss of steering. I believe this should have been covered by Safety Recall 2818I which addresses the issue. Mazda inspected and said because the recall was performed in 2019 on this car, there is nothing more they can do, once and done. Unfortunately their fix didn't take care of the issue.

• STRUCTURE

  My 2012 mazda 6 Subframe is is unsafe to drive due to over-time corrosion My local mechanics said Madzda Corp. should fix it.

• SUSPENSION

  Rear sub frame, critical fail- rusted through. Needs new rear subframe. Wheel pulling to right, unable to align. I bought this car 2 weeks ago for my 16 year old daughter and was told today it needs to be scrapped. She is devastated . We are out 4500 with no recourse. I bought a Mazda because I trusted the safety. I am so disappointed. If the front was recalled the rear should have been too.

• UNKNOWN OR OTHER

  THE REAR SUBFRAME IS RUSTED IN LAYERS AND IS SPALLING OFF.

• AIR BAGS,UNKNOWN OR OTHER

  The passenger dash board is melting. It covers the passengers air bag. I would like to know if a recall is still possible for my vehicle. I understand that there was a recall in 2015-2017, but unfortunately I did not received the notice since I was moving from Illinois to Kansas and later to Texas and continued changing addresses during that time frame.

• SUSPENSION

  Severe rusting of the rear frame and suspension

• STEERING,UNKNOWN OR OTHER

  I was driving down the road when my steering, suddenly and with out warning began pulling very hard to the right and the steering wheel began turning to the left. My car made loud noises when I tried to straighten out the steering wheel and when I tried to turn. Its also appeared to be rubbing on the inside of the wheel well. Further inspection revealed that the support where the control arm is connected to the frame had torn away from the frame due to oxidation. There is significant oxidation on the frame and there are large areas that no longer appear to be solid.

• UNKNOWN OR OTHER,STRUCTURE

  The passenger side Dash on my 2012 Mazda 6 that I just purchased 3 years ago is melting and deteriorating and it's cracked and its leaves a real bad glare on the windshield and I think they said it was a recall that was back in 2015 but this car was never fixed and that recall wasn't fixed so how do I go about getting that recall fixed because when I talk to [XXX] at Mazda direct and Fostoria they said that there was nothing they could do and it is a real bad safety hazard. INFORMATION Redacted PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6).

• STEERING,SUSPENSION,UNKNOWN OR OTHER

  I FELT SOMETHING WAS WEIRD WITH THE STEERING ONE DAY SO I WENT TO MAZDA DEALER BECAUSE I NOTICED CORROSION ON FRONT DRIVER CROSS AND REAR COMPONENTS WHICH HAVE CORROSION AND BASEBALL SIZE HOLES. INSPECTED BY LOCAL MAZDA DEALER IN EARLY 2022 WAS TOLD "WE SEE A LOT WORSE THAN THIS" SO NOTHING WAS FIXED OR REPLACED BY DEALER. OCTOBER 2022 FAILED PA STATE INSPECTION FOR SUBFRAME RUST SAFETY CONCERNS. 2023 GOT ANOTHER MECHANIC TO LOOK AND THEY ESTIMATE OVER $6,000 REPAIR COST (DOCS. ATTACHED). SERIOUS SAFETY CONCERNS CAUSES VEHICLE TO SIT UNUSED WHICH MAKES IT AVAILABLE FOR INSPECTION ANYTIME. POLICE OR INSURANCE REPRESENTATIVE WERE NOT CONTACTED BUT CAN BE IF NEEDED.

• UNKNOWN OR OTHER

  Sun/moonroof exploded. My own and others' safety were at risk due to falling broken glass The problem was not confirmed by a dealer yet The vehicle will be inspected from glass company/dealer No warning messages or lights indicated the failure.

• STRUCTURE

  Hello, I have 2012 Mazda6 was involved in a previous Safety Recall in regards to a rusting engine subframe. I was informed to bring my car in my local Mazda Dealer. My car has serious rusting issues with my subframe, Mazda decided in lieu of replacing the subframe they attached a subframe brace. While having my car serviced the mechanic and I noticed SEVERE rusting at the subframe which this recall was suppose to taken cared of. Ive attached a couple of pics but I have more that details the severe rusting. I feel a little disheartened that this recall fix the issue adequately. I want to 100% confident that the car is truely safe to drive for me and my family.